Rohde Fusing Serie Notice D'utilisation page 101

FE
Process Description
1. Open the lid by moving the 2 clamping levers
on the left and right sides of the kiln in the
Opening direction of the arrow.
the lid 2. Pull the two lid catch clamps away from the
clamping straps.
3. You can then open the lid.
1. Close the lid completely. When closing, the lid
must be pulled down completely using the
handle. For mechanical reasons, the pressure
spring cannot fully support the last few
Closing centimetres before closing.
the lid 2. After the lid has been lowered, the catch must
be guided onto the clamping straps.
3. The lid is locked using the clamping levers.
4. The lid must now be flush with the kiln casing.
5. Always ensure that the lid is properly locked.
8.4.5. Adjusting the lid handle
Adjusting the lid handle (Fusing)
99 / 298 - EN -
Illustration
The length of the lid handle can be
adjusted in one of the two positions
(1 or 2) by pulling up the catch (1)
and pulling out or pushing in.
Note:
The lid handle may only be locked
in one of the two positions shown.