Rohde Fusing Serie Notice D'utilisation page 119

15.4. Disposal
NOTE
The product must be properly disposed of at the end of its service life.
INFORMATION
It is recommended that the kiln be disposed of by a qualified specialist company.
16. Additional Information
16.1. Notice of liability
Theme
General
Misuse
Safety
Disclaimer
⇒ Electrical devices, in particular, should never be disposed of with household waste.
Electrical devices must be collected and disposed of separately for proper
treatment.
⇒ By doing this, you help with the recovery, recycling and reuse of raw materials.
⇒ Components and packaging that are easy to dispose of have been predominantly
used to protect the environment.
⇒ When disposing of the kiln, observe the country-specific laws, regulations and
standards.
Description
⇒ The kiln has been built according to the state of the art and recognised safety rules.
⇒ The protective equipment on the kiln complies with the relevant regulations.
⇒ Proper operation according to the intended use reduces the risk to people to an
acceptable level according to the current state of the art.
⇒ In the event of incorrect use, dangers to people and property can arise, as well as
damage to the kiln.
⇒ Therefore, please note:
− Only use the kiln if it is in perfect technical condition.
− Only use the kiln as intended.
− Only use the kiln in a safety and hazard-conscious manner.
− Immediately eliminate any defects or malfunctions that could impair safety.
⇒ Safety information cannot be construed against the manufacturer.
⇒ Even if all safety information, warning information and signs, operating instructions
and other applicable documents are followed, there is no guarantee that the kiln will
not cause injuries or damage.
⇒ The manufacturer assumes no liability for personal injury, property damage and
damage to the product as well as any consequential damage that arises or has
arisen from non-compliance with these operating instructions, from improper use of
the product, from repairs and any other actions of unqualified and unauthorised
specialists on the product.
⇒ Any use beyond the scope of application of the kiln described in these operating
instructions is not permitted.
⇒ The manufacturer is not liable for any resulting damage.
117 / 298 - EN -