Rohde Fusing Serie Notice D'utilisation page 100

General safety information for Fusing models
CAUTION
Risk of property damage:
Do not place any objects on the lid, as this will damage the structure of the insulating
firebricks. The insulating firebricks will break off and fall out. The manufacturer assumes no
liability or guarantee for this!
NOTE
Only the lid catch, which is located in the middle of the front of the kiln, may be used to
open the lid.
Due to the design, the models in the Fusing series have several toggle fasteners that
connect the components of the kiln casing to one another.
Fusing
Process Description
Due to the design, the models in the Fusing
series have several toggle fasteners that
connect the components of the kiln casing to
one another.
Locating the lid
catch
⇒ Only the lid catch, which is located in the
1. Open the lid by moving the clamping lever
Opening the lid 2. Pull the lid catch clamp away from the
3. You can then open the lid.
1. Close the lid completely. When closing, the
2. After the lid has been lowered, the catch
Closing the lid
3. The lid is locked using the clamping lever.
4. The lid must now be flush with the kiln
5. Always ensure that the lid is properly
Note
The lid can be secured with a padlock (not included) to protect against unauthorised opening and access to the
firing chamber.
middle of the front of the kiln, may be used
to open the lid.
in the direction of the arrow.
clamping strap.
lid must be pulled down completely using
the handle. For mechanical reasons, the
pressure spring cannot fully support the
last few centimetres before closing.
must be guided onto the clamping strap.
casing.
locked.
98 / 298 - EN -
Illustration