Rohde Fusing Serie Notice D'utilisation page 76

4.3. Hazardous area
4.3.1. General safety information
CAUTION
Risk of personal injury due to unauthorised persons remaining in the hazardous area.
4.3.2. Hazardous areas
Hazardous area
1. Electrical & thermal hazards
Firing chamber
Kiln lid
Kiln casing
View port
Electrical box, connectors,
heating elements, power
cord, electrical wiring
2. Mechanical hazards
Kiln lid, closing area
Kiln lid, swivel area
4.4. Protective equipment on the kiln
4.4.1. General safety information
DANGER
Risk of serious personal injury, property damage and even death.
⇒
⇒
⇒
⇒
⇒
Danger
Burns from hot surfaces and hot
temperatures
Burns from hot surfaces and hot
temperatures
Burns from hot surfaces
Hot exhaust air from the firing
chamber
Electric shock from:
• Open protective covers
• Defective wiring
Being crushed or becoming trapped
Being hit or caught by the lid
Note that the kiln may only be operated with functional protective equipment!
Make sure that the protective equipment is permanently installed, locked, ready for
operation and switched on!
Please comply with the relevant safety regulations for all work on the kiln, especially
when it is necessary to open, remove or switch off the respective protective
equipment.
Only make changes to protective equipment with the written approval of the kiln
manufacturer.
After working on the kiln, check that the protective equipment is functioning, even if
it is outside the prescribed inspection cycles.
74 / 298 - EN -
Remark
After the firing process is complete and
the lid is opened, the firing chamber can
still be very hot.
After the firing process is complete and
the lid is opened, the firing chamber can
still be very hot.
Observe warning signs.
Wear protective clothing and keep the
view port closed when not in use.
•
Check components regularly.
•
Repair defective components
immediately.
•
Observe warning signs.