Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CASTER REPLACEMENT
Tools Required:
• Drill
• 3/16" Drill Bit
• Pop Rivet Gun with 3/16" Tip
Procedure:
1 .
Empty and remove the wastebasket by lifting up on both corners on the back edge until it releases from the two
knobs . Set the wastebasket aside for reinstallation .
2 .
Tilt the table on its side while keeping the drop leaf facing up .
Note: Place something on the floor to protect the bedside cabinet .
3 .
Using a drill with a 3/16" drill bit, remove the two rivets that secure the caster to the base weldment .
4 .
Using a pop rivet gun with a 3/16" tip, install two new pop rivets (0025-122-000) to secure the caster to the base
weldment .
5 .
Reverse steps to reinstall .
6 .
Verify proper operation of the unit before returning it to service .
HOSPITALITY HANDLE REPLACEMENT
Tools Required:
• #2 Phillips Screwdriver
Procedure:
1 .
Using a #2 Phillips screwdriver, remove the two flat head machine screws that secure the hospitality handle to the
cabinet . Discard the handle and both screws .
2 .
Using a #2 Phillips screwdriver, install two new flat head machine screws to secure the hospitality handle to the
cabinet .
3 .
Reverse steps to reinstall .
4 .
Verify proper operation of the unit before returning it to service .
www.stryker.com
Service Information
4821-009-001 REV C
Return To Table of Contents
1-11
English
English
Publicité
Chapitres
Table des Matières
