Boston Scientific Precision Manuel page 41

Then remove the beige liner from the
patch. Secure the Charger over the
Stimulator by pressing the adhesive to
the skin over the Stimulator (see diagram
below).
• Charging Belt: Place the Charger into
the pocket on the Charging Belt with
the power button facing out. Secure the
Charger over the Stimulator by adjusting
the Charging Belt (see diagram below).
Note: If you accidentally locate the patch
in the wrong place, or if the Charging
Belt moves out of alignment, the
Charger will start beeping again. Use
a new adhesive patch or readjust the
belt to place the Charger back into
position.
Rechargeable Stimulator System
5. When the Charger emits a series of double
beeps, the Stimulator is fully charged. Turn
off the Charger, remove the Charging Belt
or adhesive patch, and return the Charger
to the Base Station. Do not confuse the
end of charge signal (a series of double
beeps) with the continuous beeps that in-
dicate that the Charger is searching for the
Stimulator.
Note: • Depending on your program
parameters, you may expect daily
recharging times from as low as
10 minutes up to four hours, or
weekly recharging times from as
low as one hour up to four hours.
Charging times may be longer than
4 hours when not properly aligned.
• The end of a charge signal is
a distinct double beep, and the
alignment indicator is a steady
continuous signal.
• Remote will not be able to
communicate with the IPG when
charging.
90607862-22 Rev A
Clinician Manual
41 of 303