Searching - Boston Scientific Precision Manuel

P
Press to link. The Remote Control will
search for the nearest Stimulator.
If the Remote Control is already linked to a
Stimulator, it may continuously search for
it. This link must be cleared before a new
link can be established. (See "Clinician
Options" page 48).
3. The Remote Control will identify the
Stimulator by serial number. Verify before
proceeding.
P
4. Press to confirm and continue. Press
to cancel.
When linking with a Trial Stimulator, the
Remote Control will ask whether existing
programs on the Trial Stimulator should
be cleared. If the programs on the Trial
Stimulator are cleared and if the Remote
Control contains existing programs, it will then
ask if these should be used.
Rechargeable Stimulator System
When linking with an IPG, the Remote
Control will automatically use any programs
stored in the IPG. If the IPG contains no
programs and the Remote Control contains
existing programs, it will ask whether to use
the programs from the Remote Control.
When the link is established, you will see the
main Level screen:

Searching

If there is a loss of communication, the
"
Remote Control will automatically begin
"searching" for the Stimulator. Move the
Remote Control closer to the Stimulator and/
or reorient its position to help it locate the
Stimulator. To cancel searching, press and
hold the button.
"
If, after searching, the Remote Control is
unable to locate a Stimulator, it will display a
90607862-22 Rev A
Clinician Manual
47 of 303