Boston Scientific Precision Manuel page 49

Note: • The Remote Control will remain CP
Ready for up to 15 minutes with no
activity.
• All buttons are active during CP
Ready and pressing any button
returns the Remote Control to the
Level screen.
• Stimulation may be turned on or off
in CP Ready state.
• Whenever the Remote Control is
re-activated from idle mode the
display will default to the Level
screen.
The Clinician Programmer can communicate
with either an External Trial Stimulator or
an IPG.
Rechargeable Stimulator System
Arrange for the patient to be seated within
two feet of the Remote Control to ensure
an adequate communication link from the
programmer to the Stimulator.
For instructions on how to use the Clinician
Programmer with the BionicNavigator
software to program the IPG and transfer
programs to the Remote Control, see the
BionicNavigator Software Guide.
Selection #2 – Impedances
When the "Impedances" option is selected
from the Clinician Options menu, the Remote
Control will measure impedances at each
contact on the lead(s). This will take about
10 seconds.
Note: During this measurement the serial
number of the Stimulator will be
displayed on the screen.
90607862-22 Rev A
Clinician Manual
49 of 303