Attaching The Power Transformer Bracket; Installing The Touch Pc Onto The Cart - Boston Scientific LithoVue Manuel D'utilisation

Figure 3�5 – Proper Placement of the cart Handle

Attaching the Power transformer Bracket

1. Attach the Cord Wrap Hook and Power Transformer Bracket's Clamping Blocks together around
the Cart Post approximately 40 cm (16") from the Cart Base. Ensure the Velcro straps for the
Power Transformer are facing forward (same direction as the Touch PC Mount). See Figure 3�9 for
correct installation with the Power Transformer.
2. Insert the (2) screws using a Phillips-head screwdriver to secure the Cord Wrap Hook and Power
Transformer Bracket firmly to the Cart Post. Be careful not to overtighten the screws.

Installing the touch Pc onto the cart

Follow these steps to install the Touch PC onto the Cart:
1. Remove the Touch PC and ancillaries from the box.
2. Confirm that all components listed in Section 3.1 "System Workstation Components" are included
in the packaging and that the components are not damaged.
3. Loosen the Tilt Adjustment Lever and adjust the mounting plate so that it is approximately vertical.
See Figure 3�6.
notE: if the Touch PC Mounting Plate is difficult to adjust, the tilt tension adjustment screws will
need to be loosened. See Section 3.2 "Adjusting Touch PC Tilt" for instructions on how to adjust
the tilt tension adjustment screws.
User's Manual 15
Black (K) ∆E ≤5.0