Boston Scientific LithoVue Manuel D'utilisation page 16

Figure 3�6 – touch Pc tilt Adjustment Lever
4. Tighten the Tilt Adjustment Lever to prevent movement of the mounting plate during assembly.
5. Using a Phillips-head screwdriver, install two of the four M4 x 10 mm Mounting Screws in the two
upper holes of the inner set of the Touch PC's VESA-mounting holes (See Figure 3�7). Leave about
1/4" of space between the head of the screw and the Touch PC.
Figure 3�7 – touch Pc Mounting Holes
6. Have an assistant lift the Touch PC using the handholds molded into the sides of the Touch PC,
and slide the two M4 x 10 mm Mounting Screws on the Touch PC into the two top slots on the
mounting plate. The assistant should hold the Touch PC in this position.
7. Using a Phillips-head screwdriver, insert and tighten the lower two M4 x 10 mm Mounting Screws
in the two lower holes of the Touch PC Mounting Plate. See Figure 3�8.
16
Black (K) ∆E ≤5.0
Tilt Adjustment Lever
User's Manual