Adjusting Touch Pc Height; Adjusting Touch Pc Tilt; Confirming Installation - Boston Scientific LithoVue Manuel D'utilisation

Adjusting touch Pc Height

cAUtIon: the touch Pc cart Post operates by pneumatic pressure and will travel upward
when disengaged� Ensure that nothing obstructs upward travel before turning the Height
Adjustment Knob� Grasp the touch Pc using the side handholds to control the upward travel
of the touch Pc when the Height Adjustment Knob is loosened�
1. To adjust the Touch PC's height, loosen the Cart's Height Adjustment Knob while supporting the
Touch PC using the handholds molded into the sides of the Touch PC. Move the Touch PC to its
desired location.
2. Tighten the Cart's Height Adjustment Knob.

Adjusting touch Pc tilt

1. To adjust the Touch PC's tilt, loosen the Cart's Tilt Adjustment Lever.
2. Grasp the handholds molded into the sides of the Touch PC and tilt to the desired angle.
3. Retighten the Tilt Adjustment Lever.
4. If the Touch PC does not hold its tilt position, use the 9/64" (3.5 mm) hex wrench provided with the
Cart to tighten the tilt tension adjustment screws equally. See Figure 3�12.
5. If the Touch PC is too difficult to tilt, use the 9/64" (3.5 mm) hex wrench provided with the Cart to
loosen the tilt tension adjustment screws equally. See Figure 3�12.
Figure 3�12 – Adjusting cart tilt
Tilt Adjustment
Lever

confirming Installation

Confirm the correct installation of the System Workstation after assembly by following these steps:
1. Verify that all fasteners on the Cart and Touch PC mounting system are secure.
2. Plug the System Workstation into the hospital's electrical outlet and ensure the switch on the Power
Transformer is turned on. The green LED on the Power Transformer will light when the Power
Transformer is turned on.
cAUtIon: to avoid risk of electric shock, ensure the Power cord is plugged into the touch Pc
before plugging the System Workstation into the hospital's electrical outlet�
3. Press the power button on the front panel to power on the System Workstation. (see Figure 3�13).
User's Manual
Tilt Tension
Adjustment Screws
19
Black (K) ∆E ≤5.0