Télécharger Imprimer la page

Salicru SLC CUBE 3+ Mode D'emploi page 79

Masquer les pouces Voir aussi pour SLC CUBE 3+:

Publicité

Les langues disponibles

Les langues disponibles

2. INFORMATION FOR SAFETY.
2.1.
USING THIS MANUAL.
• The purpose of the SLC.CUBE3+ documentation is to provide
information regarding safety and to give explanations about the
procedures for the installation and operating of the equipment.
The generic documentation of the equipment is supplied in dig-
ital format in a Compact Disc (Pendrive) and it includes among
other documents the own user's manual of the system.
• Together with this user's manual and included in the documen-
tation CD/Pendrive, it is supplied the EK266*08 document re-
garding to «Safety instructions».
Read this manual carefully before making the erection or com-
missioning, location change, setting or any king of handling in
the equipment.
Compliance as regards to «Safety instructions» is
mandatory, being the user the legal responsible
regarding to its observance and application. Read them care-
fully and follow the stated steps in the established order.
• The equipments are supplied duly labelled for the correct identification
of each part, which together with the instructions described in this
user's manual allows making any operating of the erection and com-
missioning, in an easy, ordered way, without doubt.
Finally, once the equipment is installed and working, it is recom-
mended to keep the documentation CD/Pendrive in a safe place
and with easy access, for future consults or doubts that could arise.
• When an equipment differs from the figures shown in section
4, there will be additional explanatory annexes if they were
needed. In general they will be given in hardcopy.
• The following terms are used in the document to be referred to:
ˆ «SLC.CUBE3+, CUBE3+, equipment or unit».- Uninter-
ruptible Power Supply.
Depending on the context of the sentence, it can be referred ei-
ther to the own equipment or to the equipment with batteries,
although all is assembled in one cabinet or metallic enclosure.
ˆ «Batteries or accumulators».- Group or set of elements
that store the electron flow through electrochemical means.
ˆ «T.S.S.».- Technical Service & Support.
ˆ «Client, installer, operator or user».- Both are used, but
it also includes the terms of fitter and/or operator, who will
make the corresponding actions, being able to fall over this
person the responsibility of making the respective actions to
act in the name or behalf of the user.
• In case of installing the equipment in IT neutral regime, the
switches and circuit breaker protections must break the NEU-
TRAL as well as the three phases .
• Inside the battery cabinet there are accessible parts with HAZ-
ARDOUS VOLTAGES, so electrical shock risk exists, therefore it
is classified as RESTRICTED ACCESS AREA. This is why the key
of the battery cabinet will not be available to the OPERATOR or
END USER, unless he has been trained properly.
SALICRU
2.1.1.
Conventions and used symbols.
Some symbols can be used and shown in the equipment, batteries
and/or in the context of the user's manual.
For more information, see section 1.1.1 from EK266*08 document
regarding to «Safety instructions».
79

Publicité

loading