Stryker 6000-801-000 Mode D'emploi page 13

4.2 Preparing the Tracker Sleeve
1. Prepare the Tracker Sleeve by
attaching the 4 Navigation Spheres
to the tracker post.
4.3 Validating the Tracker Sleeve
For instructions on how to use the Validation Tip for the validation of the
Tracker Sleeve in conjunction with the software application, refer to the user
manual supplied with the software application.
1. Press the push button of the Tracker
Sleeve (a).
2. Insert the Validation Tip into the
Tracker Sleeve (b).
→ The Validation Tip needs to be fully
inserted into the Tracker Sleeve.
3. Place the Validation Tip in the
Calibration Body's cone. Ensure the
Validation Tip touches the bottom of
the cone.
Stryker
Figure 4: Attaching the Navigation Spheres to the tracker post.
a
Figure 5: Inserting the Validation Tip.
Figure 6: Validation Tip in the Calibration Body's cone.
Preparation for use
b
9