Increasing/Decreasing Pulse Width
To increase or decrease the pulse width of the selected Area:
1. Select and release the
width. Select and hold the
2. Select and release the
width. Select and hold the
Note: The Pulse Width control is not displayed when the Program Tab in the Parameters panel is
selected.
Increasing/Decreasing Rate
To increase or decrease the rate of the selected Area:
1. Select and release the
and hold the
2. Select and release the
and hold the
Note: The Rate control is not displayed when the Program Tab in the Parameters panel is selected.
Using the Keyboard Shortcuts
The follow keyboard shortcuts can be used during the programming session:
Key
Function
Q
Turn Therapy OFF
A
Increase stimulation amplitude
Z
Decrease stimulation amplitude
/
Selected Area is copied to the first available Temporary Area
I
Steer up (for E-Troll, Navigate, FAST I3D, and Contour modes only)
M
Steer down (for E-Troll, Navigate, FAST I3D, and Contour modes only)
J
Steer left (for E-Troll, Navigate, FAST I3D, and Contour modes only)
L
Steer right (for E-Troll, Navigate, FAST I3D, and Contour modes only)
button under "Pulse Width" to incrementally increase the pulse
button to increase pulse width at a faster rate.
button under "Pulse Width" to incrementally decrease the pulse
button to decrease pulse width at a faster rate.
button under "Rate" to incrementally increase the rate. Select
button to increase rate at a faster pace.
button under "Rate" to incrementally decrease the rate. Select
button to decrease rate at a faster pace.
Programming the Patient
Bionic Navigator™ 3D 4.0 Programming Manual
92395591-02 37 of 1595