Boston Scientific Bionic Navigator 3D 4.0 Manuel De Programmation page 50

Bionic Navigator™ 3D 4.0 Programming Manual
To Cycle the currently active Program:
1. Select next to the Program Name.
2. Select Options.
3. Select the Cycle option from the Program tab or the Area tab.
Note: If the Cycle button is selected on the Program Options screen, all Areas will be cycling by
default. To change the cycling option of a particular Area, select the Area tab and check/uncheck
the Cycle box for the desired Area.
4. Choose an ON time and an OFF time from the respective drop-down menus.
5. Select OK.
Cycling one or more Areas within a currently active Program at Different Cycle times:
1. Select next to the Program Name.
2. Select Options.
3. Select the Continuous option from the Program tab.
4. Go to the Area tab.
5. Select the Cycle check box for the desired Areas.
6. Choose an ON time and an OFF time from the respective drop-down menus.
7. Select OK.
Creating a MicroBurst waveform in an Area:
1. Select next to the Program Name.
2. Select Options.
3. Select the MicroBurst option from the Program tab. Note: Ramp Up is unavailable when
MicroBurst is enabled.
4. Go to the Area tab.
5. Choose the desired number of pulses using the ON drop-down menu.
6. Choose the desired off time between bursts by using the OFF drop-down menu.
The "inter-burst" and "intra-burst" frequencies can be viewed in the Area tab screen as shown
in Figure 25b. Inter-burst frequency is the frequency between burst packets. Intra-burst
frequency is the frequency within each burst.
7. Select OK. After enabling MicroBurst, the MicroBurst icon
corner of the full view programming screen.
To specify the Min or Max mA for the currently active Program or for a specific Area:
1. Select next to the Program Name.
2. Select Options.
Bionic Navigator™ 3D 4.0 Programming Manual
92395591-02 44 of 1595
will be displayed in the top left