Increasing And Decreasing The Pulse Width - Boston Scientific Vercise DBS Mode D'emploi

Increasing and Decreasing the Pulse Width

The pulse width of the stimulation describes the length of time a burst of energy is applied to the
desired area. The pulse width is measured in microseconds (µS).
1
To increase the pulse width, click or click and hold the
the Programming Screen.
Note: If you attempt to adjust the pulse width above the charge density limit, then you will
see a caution message.
2
To decrease the pulse width, click or click and hold the
Programming the Patient
button below the PW label on
button below the PW label.
Vercise™ DBS Programming Manual
91053785-07 27 of 323