Increasing And Decreasing The Pulse Width - Boston Scientific Vercise DBS Mode D'emploi

Increasing and Decreasing the Pulse Width

The pulse width of the stimulation describes the length of time a burst of energy is
applied to the desired area. The pulse width is measured in microseconds (µS).
1 To increase the pulse width, click or click and hold the
label on the Programming Screen.
Note: If you attempt to adjust the pulse width above the charge density limit, then
you will see a caution message.
2 To decrease the pulse width, click or click and hold the
label.
Programming the Patient
button below the PW
button below the PW
Vercise™ DBS Programming Manual
91053785-17 27 of 1705