Using E-Troll Mode; Using Navigate Mode; Using Fast I3D Mode - Boston Scientific Bionic Navigator 3D 4.0 Manuel De Programmation

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 82
Bionic Navigator™ 3D 4.0 Programming Manual

Using E-Troll Mode

To program in E-Troll mode for the selected area:
1. Select the Area you would like to program.
Note: If a new Area is created, selecting E-Troll mode will automatically define the electrode
programming so that the CPS is at the top left corner of your Lead configuration. However, if
no changes are made to the Area, it will not be saved.
2. Select the Lead Group you would like to use. Only one Lead Group can be used per Area.
3. Select E-Troll in the Programming Mode drop-down list.
4. Point and Click to place the CPS to the area of interest on the screen.
5. Adjust Amplitude until strength of stimulation is at the desired level.
6. Use the steering direction arrows to move the CPS left, right, up, or down.
7. Adjust Advanced Options as needed. Refer to "Understanding the Advanced Options".
Note: Amplitude, Pulse Width and Rate may be adjusted at any time.
Note: When a different Lead Group is selected, any existing electrode configuration for the highlighted
Area will be cleared.

Using Navigate Mode

To program in Navigate mode:
1. Select the Area you would like to program.
2. Select the Lead Group you would like to use. Only one Lead Group can be used per Area.
3. Select Navigate in the Programming Mode drop-down list.
4. Point and Click to place the CPS to the area of interest on the screen.
5. Adjust Amplitude until strength of stimulation is at the desired level.
6. Use the steering direction arrows to move the CPS left, right, up, or down.
7. Adjust Advanced Options as needed. Refer to "Understanding the Advanced Options".
Note: Amplitude, Pulse Width or Rate may be adjusted at any time.
Note: If a new Area was created, selecting Navigate mode will automatically define the electrode
programming so that the CPS is at the top left corner of your Lead configuration.
Note: When a different Lead Group is selected, any existing electrode configuration for the highlighted
Area will be cleared.

Using FAST I3D Mode

1. Select the Area you would like to program
2. Select the Lead Group you would like to start with.
Bionic Navigator™ 3D 4.0 Programming Manual
92395591-02 34 of 1595

Publicité

Table des Matières
loading

Table des Matières