During Use; Control Pedal Configurations - SICE S 200 Manuel D'instructions

RISK OF INJURY DUE TO CRUSHING. The pole rotation and the bead breaking
operation must be performed from working position A, keeping hands away from
machine moving parts.

1.11 During use

RISK OF INJURY DUE TO CRUSHING. The pole rotation and the bead breaking
operation must be performed from working position A, keeping hands away from
machine moving parts.
If strange or unusual noises are heard or any unusual vibration is detected, if a component
or system is not operating correctly or if you observe anything unusual, immediately
stop using the machine.
• Identify the cause and take any necessary remedial action.
• Contact your supervisor if necessary.
Make sure that all other people are standing at least 6 metres from the machine.
To switch off the machine in case of emergency:
• disconnect the power supply plug;
• cut off the compressed air supply line by disconnecting the shut-off valve (quick
coupling).

1.12 Control pedal configurations

Avoid unintended machine operation as this can lead to possible personal injury. Pay
close attention to the configuration of your machine.
Manuale d'uso S 200
CAUTION
WARNING
WARNING
Pneumatic power supply cut-off can leave some
actuators under pressure, as indicated by the
pictogram applied to the machine. Use the controls
to bleed the air they contain.
CAUTION
117