Operator Position - SICE S 200 Manuel D'instructions

These checks must be carried out:
• Before starting the machine.
• At regular time intervals.
• After any modification or repair.
The machine may only be started after this pre-use check is successfully completed.
Do not use the machine if it is placed out of service for tune up, maintenance, lubrication,
etc.

1.10 Operator position

The figure below shows the operator's positions and the relevant hazardous areas
during the various work phases:
The operator is in position "A" during the tyre bead breaking, demounting, mounting
and inflation phases.
A
116 Manuale d'uso S 200