Technical Assistance; Job Count; Unauthorised Use - SICE A98 Manuel D'instructions

This window is used to check the correct operation of the targets when they are used on a vehicle.
The following keys are active in this window:
- F1 displays the on-line "Help" function
- F2 goes back to the previous window
- F10 goes back to the starting menu window.
Window for use by the technical support service only.
Users are urged not to access this window. Improper use of the procedures in this program
section may cause aligner malfunctions.
This option is visible only if previously enabled in the wheel aligner general set-up.
To access the "Job Count" window, enter the password (the password is not indicated in this
manual for security reasons).
If interested in this option, please request the password from the support service.
The total count of the jobs performed is indicated in the left section of the two-section window
(Fig. 29). In the left section, the job count per working day is displayed together with a calendar
from where to choose a day to be viewed.
Three boxes are located above the calendar, where the desired day, month and/or year can be
selected for rapid selection of the date searched. After setting the date, confirm the selection by
pressing the "Enter" key
This window behaves like message windows, where the active function keys are in the window,
whereas the function bar keys are disabled.
The following keys are active in this window:
- F2 returns to the previous window
- F4 resets the overall job count to zero.
Notes
When resetting the overall job count to zero, only the overall count is reset to zero, while the
number of jobs saved every day is not altered.
It is forbidden to use the aligner for any purpose other than measuring the characteristic
alignment angles of a vehicle (see description in the chapter "Characteristic Angles").
Use of the aligner for any purpose other than its original function releases the
manufacturer from all responsibility for any damage or injury that may result.
It is recommended to use the Personal Computer installed in the measuring unit only with the
programs supplied by the builder.
The software in the HARD DISK and in the update CD ROMs are the property of the
builder and can be used only with the personal computer supplied with the machine.

Technical Assistance

Job count

UNAUTHORISED USE

WARNING
ATTENTION
39