Demounting Standard Tyre From Rim - SICE S 200 Manuel D'instructions

2.3 Demounting Standard Tyre from Rim

Always follow these instructions to use the leverless mounting head
2 mm
1,5 mm
CHECK MONTHLY
THE CALIBRATION OF THE
MOUNTING HEAD
Demounting upper bead
Position the mounting/demounting head against the outer edge of the upper rim lip.
The plastic surfaces must be in contact with the rim lip.
Slide the mounting/demounting head in or out along the upper rail and lower the head
into position. Lock the lever. Adjust the diameter knob for correct side spacing. The
mounting / demounting head will automatically build in the proper vertical spacing.
Always make sure the wheel is being rotated while inserting the automatic lever.
Locate an area with a gap between the tyre and the wheel.
Press the wheel rotation pedal
insert the automatic lever into the rim / tyre assembly using the control switch.
Manuale d'uso S 200
CAUTION
LUBRICATE
ALWAYS ALWAYS MOUNT WITH THE BEAD
LUBRICATE THE ON THE BACK OF THE MOUNTING
TYRE
CAUTION
to rotate the wheel clockwise. While rotating,
USE THE APPROPRIATE
ACCESSORIES TO PREVENT
ANY POSSIBLE DAMAGE
HEAD
129