Basic Procedure; Placing Wheel On Tyre Changer - SICE S 200 Manuel D'instructions

1- Pole rotation pedal
2- Inflation pedal
3- Backing pad rotation pedal
4- Mirror
5-
Accessory tray
6- Inflation head
7-
Upper bead breaker
8- Support for cones for accessories
9- Lower bead breaker
10- Vertical rod locking control
11- Bead presser handle
12-
Bead presser
13- Wheel locking handle
14- Lubricator / Filter / Regulator
15- Leverless control head
16- Backing pad
17-
Bead presser cylinder control
18- Grease-holder support
19-
Paintbrush support
20- Upper bead breaker out-of-work position lever
21- Upper bead breaker penetration button
22- Upper bead breaker vertical control
23- Lower bead breaker vertical control
24-
Lower bead breaker penetration button
25- Leverless head control lever
26- Bead breaker horizontal shifting control
27- Pressure gauge
28- Air discharge button

2. BASIC PROCEDURE

2.1 Placing Wheel on Tyre Changer

Identify and recognize special wheel combinations such as tilted channel wheels
(they need to be inverted on the tyre changer), AH, "Run-Flat" and standard tyres
with pressure sensors. If you are not familiar with these special types of wheels, DO
NOT USE the tyre changer. Consult with the technical personnel.
Lock the wheel on the turntable
Load the wheel on the turntable. When positioning the wheel on the turntable, also take
Manuale d'uso S 200
CAUTION
125