SICE S 200 Manuel D'instructions page 128

2. Activate disc penetration
bead breaker disc a little at a time
3. Perform at least one complete rotation to fully break the bead. The tyre bead should be
greased during the rotation.
4. Set the upper arm upwards over the wheel with control
Lower bead breaking
1. Preload the bead breaker disc using control
is advisable).
2. Activate disc penetration
bead breaker disc a little at a time
3. Perform at least one complete rotation to fully break the bead. The rim bead should be
greased during the rotation.
4. Set the upper arm downwards below the wheel with control
128
and then start wheel spinning
.
(a tyre crushing preload of about 5 mm
and then start wheel spinning
.
while lowering the
.
while lowering the
.
Manuale d'uso S 200