SICE S 200 Manuel D'instructions page 93

Proceed with caution to prevent any injuries. Carefully read, understand and follow the warnings
and instructions given in this manual. This manual is an integral part of the product. For future
reference, store it together with the machine in a safe place.
4. Never exceed the inflation pressure for the tyre indicated by
the manufacturer on the side of the tyre itself.
Carefully check that the air hose is well inserted in the valve.
5. Never place your head or any part of your body over a tyre
during inflation process or when attempting to seat beads.
This machine is not a safety device against the possible risk of
explosion of tyres, tubes or rims.
6. Always keep a safe distance from the tyre changer when
inflating, do not approach it.
A bursting tyre can cause projections of its parts in surrounding areas with a force sufficient to
cause serious injury or death.
Never mount any tyre unless its size (moulded into the sidewall) matches the rim size (stamped
into the rim) exactly or if the rim or tyre are defective.
Never exceed tyre pressure recommended by tyre manufacturer.
The tyre changer is not a safety device and does not prevent tyres and rims from exploding.
Keep all persons not working on the machine out of the working area.
7.Crushing hazard. Presence of moving parts. Contact with moving
parts can cause accidents.
• Only one operator may work with the machine at a time.
• Keep bystanders away from the tyre changer.
• Keep your hands and fingers away from the rim edge during the
demounting and mounting process.
• Keep hands and fingers clear of mount/demount head during
operation.
• Keep your hands and other body parts away from moving parts.
• Do not use tools other than those supplied with tyre changer.
• Use lubricant that is specific for tyres in order to prevent tyre binding.
8. Danger of electric shock.
• Do not clean electric tyre changers using water or pressure.
• Do not operate the machine in the presence of a damaged electrical
cable.
• If an extension cable is necessary, use a cable with a rated current
equal to or greater than that of the equipment. Cables with rated
features that are lower than those of the machine could overheat
Manuale d'uso S 200
CAUTION
DANGER
93