SICE S 200 Manuel D'instructions page 149

3. The tool head should be touching the rim at the points shown below:
TOOL HEAD
SHOULD TOUCH
RIM AT THIS
POINT
4. Tighten the side adjustment screws, but not completely.
Radial adjustment of the tool head
1. Release the tool head, then reposition it on the rim and lock it in place with the head
position lock.
2. Adjust the two front adjustment screws and set the tool head so the left side is touching
the rim and the right side is flush with the rim edge.
TOOL HEAD
SHOULD BE
FLUSH WITH
RIM EDGE
3. Fully tighten the adjustment screws starting with the head retaining bolt.
Release the pole and reposition the tool head on the rim for gap adjustment.
Adjusting the vertical gap
1. Reposition the tool head on the rim and lock it in place with the head position lock.
Using a thickness gauge, check the distance between the tool head and the rim. The
distance should be 1.5 mm (0.06 inch).
Manuale d'uso S 200
TOOL HEAD
SHOULD TOUCH
RIM AT THIS
POINT
TOOL HEAD
SHOULD TOUCH
RIM AT THIS
POINT
149