Intended Use Of The Machine; Personnel Training; Preliminary Checks - SICE S 200 Manuel D'instructions

1.7 Intended use of the machine

This machine must be used only to remove and replace an automotive tyre on an
automotive rim or a motorcycle tyre on a motorcycle rim, using the tools with which it is
equipped. Any other use is improper and may cause accidents.

1.8 Personnel training

1. Employers are responsible for providing a training program for all employees who
work on the wheels concerning the hazards deriving from maintenance and the safety
procedures to be observed. Service or Maintenance means mounting and demounting
of rim wheels, and related activities such as inflating, deflating, installing, removing and
handling.
• Employers are required to make sure that operators do not work on the wheels unless
they have received suitable training regarding the correct maintenance procedures for
the type of wheel being serviced and the operative safety procedures.
• Information to be used in the training program shall include, at a minimum, the applicable
information contained in this manual.
2. Employers are required to make sure that every employee demonstrates and maintains
the ability to work on the wheels safely, including the performance of the following activities:
• Demounting of tyres (including deflation).
• Inspection and identification of the rim wheel components.
• Mounting of tyres.
• Use of any restraint device, cage, barrier, or other installation.
• Handling of rim wheels.
• Inflation of the tyre.
• Move away from the tyre changer while inflating the tyre and do not lean over to inspect
the wheel during inflation.
• Installation and removal of rim wheels.
3. Employers must evaluate the ability of their employees to carry out these tasks and
work on the wheels in absolutely safety and must provide additional training as required
to make sure that all employees maintain their skills.

1.9 Preliminary checks

Before starting to work, carefully check that all components of the machine, especially
rubber or plastic parts, are in place, in good condition and working properly. If the
inspection reveals any damage or excessive wear, no matter how slight, immediately
replace or repair the component.
Walk around the machine to ensure that all components are in good condition and
operational, and that there are no foreign objects or debris (rags, tools, etc...) in or
about the machine which could affect its operation.
Manuale d'uso S 200 115