SICE S 200 Manuel D'instructions page 112

Make sure that the electrical supply circuit and relevant socket are properly grounded.
To prevent the possibility of electrical shock injury or damage to the equipment when
servicing the S 200, power must be disconnected by removing the power cable from the
electrical power outlet.
After servicing, be sure the S 200 ON/OFF switch is in the "O" (off) position before
plugging the power cable into the electrical power outlet.
Electrical precautions
The S 200 tyre changer is equipped with motor inverter, (220VAC / one phase / 50-60Hz).
This machine must be connected to a 20 amp branch circuit. Please refer all power
supply issues to a certified electrician.
A protective ground connection, through the grounding conductor in the power
cable, is essential for safe operation. Use only a power cable that is in good
condition.
Equipment installation and service
The installation procedure must be entrusted to an authorised representative of the company.
This equipment contains no user serviceable parts. All repairs must be performed by a
Corghi service technician.
Equipment specifications
Voltage:
Amperage:
Pneumatic System Requirements:
112
DANGER
• HAZARDOUS VOLTAGE
• Turn off and lock out system power before
servicing.
• Contact may cause electric shock or death
CAUTION
Electrical system
220 VAC / one phase / 50-60 Hz
Pneumatic system
8-12.0 bar (115-175 PSI)
20 amperes
Manuale d'uso S 200