SICE S 200 Manuel D'instructions page 151

3. If the gap is not correct, release the head position lock and adjust the nuts beneath the
horizontal pole locking system cover to adjust the gap. The cover must not be removed.
Loosen the nuts to increase the gap and tighten to reduce the gap.
HORIZONTAL POLE
LOCKING SYSTEM
To ensure that the horizontal locking plate functions correctly, the two nuts must
be adjusted symmetrically.
4. Reposition the tool head on the rim and lock it in place with the head position lock.
Re-check the gap.
5. When the adjustments are complete, check the gap between the hook of the tool head
and the external safety hump of the rim. The distance should be between 0.08 and 0.16
inches. Otherwise, repeat the calibration procedure.
6. At the end of the procedure mount the cover.
Manuale d'uso S 200
REMOVE THE
COVER
CAUTION
ADJUSTMENT
NUT
2-4 mm (0.08 - 0.16
inch) GAP
151