Electrical And Pneumatic Connections; Mounting/Demounting Head Calibration; Final Steps - SICE S 200 Manuel D'instructions

1.5.6. Electrical and pneumatic connections

1. Firmly connect the pneumatic supply to the tyre changer.
2. Check that the operating pressure is between 8 and 10 bar (100-145 psi).
3. The tyre changer is equipped with a supply cable without electrical plug.
Insert the suitable plug in a socket compliant with the requirements of 230V-50/60Hz-
20A. When the mounting is complete, check for air leaks and check all tyre changer
functions.

1.5.7. Mounting/demounting head calibration

In order to calibrate the mounting/demounting head, see section 3.4 of this manual.

1.5.8. Final steps

1. Fit the grease seal ring.
2. Apply the assembly paste on the suitable ring.
Manuale d'uso S 200
DANGER
Before making the electrical and pneumatic hook-ups
and whenever the electrical and pneumatic supply is
restored, make sure that the machine is configured as
described below:
- AUTOMATIC POLE pedal pressed fully down
(operating position);
- lifting device drive valve (optional) activated, fully press
down the slider located on the top part of the valve.
107