SICE S 200 Manuel D'instructions page 105

4. Then fit the spacers on the casing using the included hexagon socket head M8 screws
and washers, leaving a clearance between washer and spacer so that the lifting device
can be later inserted, as shown below.
5. Fit the upper spacer using the supplied hexagon socket head M8 screw, washer and
nut, then fully tighten the three screws used to fit the spacers so that the lifting device
is locked to the machine.
6. Fix the stabiliser connecting rod to the platform pin using the Seeger ring supplied
and placing shim washers in-between in both sides.
7. Fix the main arm of the platform using the pin and the H9.5 spacers as shown below
Manuale d'uso S 200 105