SICE S 200 Manuel D'instructions page 153

Before carrying out cleaning or maintenance operations on the machine, or when
replacing machine parts, turn off the machine, and disconnect all power sources. Follow
any "lock out/tag out" procedures in your jurisdiction. Consult your supervisor for
additional information.
Should any maintenance task require the disabling, removal or disassembling of
any safety device, that device must be immediately restored or replaced when the
maintenance is complete.
Wear clothing and personal protective equipment (PPE) that are compliant with the
local rules and regulations, including but not limited to OSHA. Consult with the technical
personnel for instructions.
The SICE products' components are designed as a single integrated system. To avoid
compromises in terms of safety, performance, durability and functionality, and to
maintain the validity of the warranty, never replace SICE components with spare parts
manufactured by other companies. Only use ORIGINAL spare parts supplied by the
manufacturer.
During maintenance procedures,
• Never modify or alter the machine or any of its components.
• Use proper stairs, ladders or platforms to access areas that cannot be reached from
ground level.
• Use appropriate personal protection equipment (PPE), such as eye protection, face
shield, respiratory protection, gloves and coveralls, when performing maintenance,
repairs or adjustments in compliance with local and OSHA regulations. Check with your
supervisor.
• Never attempt any repairs or adjustments to any hydraulic component or auxiliary
unit, including pumps, hoses, fittings, if the system is pressurized or operational or if the
machine is in operation. Always shut down the machine, relieve all pressure and wait for
all motion to come to a complete stop before performing any repairs or adjustments.
Maintenance
programme
Daily
Manuale d'uso S 200
Carry out the following maintenance
Drain condensation from pressure regulator reservoir by
pressing in on the fitting located on the bottom of the
regulator.
Check for worn or damaged rubber and nylon components
that should be replaced to prevent damage. Replace
worn parts as needed (tool supports, rubber pads, lever
protector sleeve and mounting/demounting head).
Clean all the areas in contact with rims or tyres in order to
prevent any scratches on the rims.
153