Keysight Technologies N6700C Serie Guide D'utilisation page 94

Select an Output Channel
Front Panel Menu Reference
Press the Channel key to select an output channel.
Set the Output Voltage
Front Panel Menu Reference
Press the Voltage key.
Enter a voltage value. Then press Select.
For models with multiple ranges, you can select a lower range if you need better output resolution.
Front Panel Menu Reference
Press the Voltage key.
Select a lower range. Then press Select.
For Keysight Models N678xA SMU
Voltage limit, which limits the output voltage at the specified value. In current priority mode, the
output current remains at its programmed setting as long as the output voltage is within the positive
or negative limit. Check Tracking to let the negative voltage limit track the positive voltage limit.
Front Panel Menu Reference
Press the Voltage key.
Specify a + Voltage limit and or a − Voltage limit. Then press
Select.
Check the Tracking box if you want the − limit to track the + limit.
Set the Output Current
Front Panel Menu Reference
Press the Current key.
Enter a current value. Then press Select.
Keysight N6700C Series User's Guide
SCPI Command
Enter the selected channel(s) in the command's
parameter list.
OUTP:STAT? (@1,2)
SCPI Command
To set output 1 to 5 V:
VOLT 5,(@1)
To set all outputs to 10 V:
VOLT 10,(@1:4)
SCPI Command
To select the lower range, program a value that
falls within the range:
VOLT:RANG 5,(@1)
operating in current priority mode, you can specify a
SCPI Command
To select the voltage limit:
VOLT:LIM 5,(@1)
To select the negative voltage limit:
VOLT:LIM:NEG 3,(@1)
To enable voltage limit tracking:
VOLT:LIM:COUP ON,(@1)
SCPI Command
To set output 1 to 1 A:
CURR 1,(@1)
To set all outputs to 2 A:
CURR 2,(@1:4)
4 Operating the Power System
93