Publicité
Les langues disponibles
Les langues disponibles
2 Installation
Auxiliary Measurement Connections
This information only applies to Keysight Models N6781A and N6785A.
The auxiliary voltage measurement input is located on the rear panel of the Keysight N6781A and
N6785A. It is primarily used for battery voltage rundown measurements, but it is also suitable for
general purpose DC measurements.
The auxiliary voltage measurement input is isolated from other commons. It has a bandwidth of about
2 kHz. It has one input range: −20 to +20 VDC.
As shown in the following figure, auxiliary voltage measurements cannot be made on test points that
are at a greater potential than ±60 VDC from ground. Refer to
more information.
When using the auxiliary voltage measurement input, no output terminal or
measurement input terminal may be more than ± 60 VDC from any other terminal
and chassis ground.
70
Auxiliary Voltage Measurements
Keysight N6700C Series User's Guide
for
Publicité
