Keysight Technologies N6700C Serie Guide D'utilisation page 93

4 Operating the Power System
Programming the Output
Select a Channel View
Select an Output Channel
Set the Output Voltage
Set the Output Current
Set the Output Resistance
Set the Output Power
Set the Output Mode
Set the Slew Rate
Enable the Output
Sequence Multiple Outputs
Program the Output Relays
Set the Output Bandwidth
Set the Output Turn-Off Mode
Programming an Input Short
Enable Under-Voltage Inhibit
When the power system is first turned on, it may take about 20 seconds or so to
initialize the instrument before it is ready for use.
If a menu item is grayed-out, it is not available for the module, or not available in the
mode that is presently selected.
Keysight N679xA Load Module input terminals are referred to as "Outputs" throughout
this document
Select a Channel View
Front Panel Menu Reference
Press the Meter key to toggle between single-channel and
multiple-channel view.
92
.
SCPI Command
To select single-channel view:
DISP:VIEW METER1
To select multiple-channel view:
DISP:VIEW METER4
Keysight N6700C Series User's Guide