Keysight Technologies N6700C Serie Guide D'utilisation page 106

When a trigger is received, the triggered functions are set to their programmed trigger levels. When
the triggered actions are completed, the trigger system returns to the idle state.
You can test the TRAN_active bit in the Operation Status register to know when the transient trigger
system has returned to the idle state.
Front Panel Menu Reference
Not Available
If a bit value of 64 is returned in the query, the TRAN_active bit is true, and the transient action is NOT
complete. When the TRAN_active bit is false, the transient action is complete. Refer to Status Tutorial
in the Operating and Service Guide document for more information.
Generating Trigger-Out Signals
Each output channel can generate trigger signals that can be used by other output channels, or
routed to a pin on the digital port that has been configured as a trigger output (TOUT). Use the
following commands to program transient trigger signals that are generated when an output Step
occurs.
Front Panel Menu Reference
Use the Channel key to select the channel that is the
trigger source. Select Transient\Step.
Check Enable Trig out. Then press Select.
Keysight N6700C Series User's Guide
SCPI Command
To query the TRAN_active bit (bit 6):
STAT:OPER:COND?
SCPI Command
To program channel 3's step function to generate a
trigger signal, use
STEP:TOUT ON,(@3)
4 Operating the Power System
105