Keysight Technologies N6700C Serie Guide D'utilisation page 111

4 Operating the Power System
Only two of the digital connector pins on each mainframe can be configured as "ONCouple" and
"OFFCouple" on each synchronized mainframe. The designated pins will function as both an input and
an output, with a negative transition on one pin providing the synchronization signal to the other pins.
Front Panel Menu Reference
For mainframe #1, select System\IO\DigPort\Pins.
Select pin 6, then Function, then On Couple.
Select Pins., select pin 7, then Function, then Off
Couple.
Repeat these steps for mainframes #2 and #3.
Synchronization Operation
Once configured and enabled, turning the output on or off on any coupled channel will cause all
coupled channels on all configured mainframes to turn on or off according to their user-programmed
delays. This applies to the front panel On/Off key, the Web server, and to SCPI commands.
If a mainframe has its ON/OFF key coupled (located in the System\Preferences\Keys menu), turning
the output on or off on any coupled channel will cause all coupled channels as well as non-coupled
channels on that mainframe to turn on or off.
110
SCPI Command
To configure pin 6 of mainframe #1 as the ON control:
DIG:PIN6:FUNC ONC
To configure pin 7 of mainframe #1 as the OFF control:
DIG:PIN7:FUNC OFFC
Repeat these commands for mainframes #2 and #3.
Keysight N6700C Series User's Guide