Publicité
Les langues disponibles
Les langues disponibles
4 Operating the Power System
Front Panel Display
View
You can specify how the output channels are displayed at turn on.
Front Panel Menu Reference
Select System\Preferences\Display\View
Check Voltage, Current to display one channel.
Check Volt, Curr, Power to display voltage, current and
power in one-channel view.
Check 4-channel to display all channels.
Contrast
You can set the contrast of the front panel display to compensate for ambient lighting conditions. The
contrast can be set from 0% to 100% in increments of 1%. As-shipped, the contrast is set to 80%.
Front Panel Menu Reference
Select System\Preferences\Display\Contrast
Enter a contrast value in the Contrast box. Then press Select.
Screen Saver
The power system has a front panel screen saver that significantly increases the life of the LED display
by turning it off during periods of inactivity. The delay can be set from 30 to 999 minutes in 1 minute
increments. As shipped from the factory, the screen saver comes on one hour after activity on the front
panel or interface has ceased.
When the screen saver is active, the front panel display turns off, and the LED next to the Line switch
changes from green to amber. To restore the front panel display, simply press one of the front panel
keys. The first action of the key turns the display on. Subsequently, the key will revert to its normal
function.
If the Wake on I/O function is selected, the display is restored whenever there is activity on the remote
interface. This also resets the timer on the screen saver. As shipped, Wake on I/O is active.
160
SCPI Command
To display one channel:
DISP:VIEW METER1
To display voltage, current and power in one-channel
view:
DISP:VIEW METER_VIP
To display all channels:
DISP:VIEW METER4
SCPI Command
Not available
Keysight N6700C Series User's Guide
Publicité
