Publicité
Les langues disponibles
Les langues disponibles
4 Operating the Power System
Enter the values for the level before and after the ramp.
Enter the time before the ramp, the rise-time of the ramp, and the time after the ramp.
Front Panel Menu Reference
Select Transient\Arb\Config\Ramp\Level.
Enter the Start and End level in volts. Then press Select.
Select Transient\Arb\Config\Ramp\Time.
Enter the Start, Rise, and End times in seconds. Then press
Select.
Step 3. Configure the final steps common to all Arbs. Refer to
the end of this section.
Configuring Trapezoid Arbs
Step 1. Select the Arb Type and Shape. Power and Resistance types apply to
Front Panel Menu Reference
Select Transient\Arb\Function.
Select a Voltage, Current, Power, or Resistance Arb Type.
Then select the Trapezoid Shape. Then press Select..
Step 2. Configure the trapezoid parameters. The parameters apply to the selected Arb type (Voltage,
Current, Power, or Resistance).
Enter the values for the level before and during the top of the trapezoid.
Enter the time before the trapezoid, the rise-time, top-time, fall-time, and the time after the trapezoid.
120
SCPI Command
To configure a voltage ramp Arb, use:
ARB:VOLT:RAMP:STAR 0, (@1)
ARB:VOLT:RAMP:END 10, (@1)
ARB:VOLT:RAMP:STAR:TIM 0.25,(@1)
ARB:VOLT:RAMP:RTIM:TIM 0.5,(@1)
ARB:VOLT:RAMP:END:TIM 0.25,(@1)
Configuring Steps Common to all Arbs
SCPI Command
To select a current, voltage, power, or resistance trapezoid
Arb, use:
ARB:FUNC:TYPE VOLT|CURR|POW|RES,(@1)
ARB:FUNC:SHAP TRAP,(@1)
Keysight N6700C Series User's Guide
at
.
Publicité
