Keysight Technologies N6700C Serie Guide D'utilisation page 103

4 Operating the Power System
Stepping the Output
Enable the output to respond to trigger commands
Program the step trigger levels
Selects the transient trigger source
Initiate the transient trigger system
Trigger the output step
Generating Trigger-Out Signals
The transient system lets you step the output voltage, current, resistance, or power up or down in
response to triggered events. This section describes the procedure to generate triggered output
steps.
Enable the output to respond to trigger commands
First, you must enable the output to respond to Step triggers. Unless an output is enabled to respond
to triggers, nothing will happen even if you have programmed a trigger level and generated a trigger
for the output. Resistance and Power step triggers apply to
selected Arb type (Voltage, Current, Power, or Resistance).
Use the following commands to enable an output to respond to step triggers:
Front Panel Menu Reference
Select Transient\Mode.
Set dropdown of the the specified function to Step.
Then press Select.
In Step mode, the triggered value becomes the immediate value when the trigger is
received. In Fixed mode, trigger signals are ignored; the immediate values remain in
effect when a trigger is received.
Program the step trigger levels
Next, use the following commands to program a triggered level. The output will go to this level when
the trigger is received. Resistance and Power trigger levels apply to
If you have a model that has multiple ranges, the selected triggered settings must be within the same
range that the output channel is presently operating in
102
SCPI Command
To enable the specified function to respond to step
triggers, use:
VOLT:MODE STEP,(@1)
CURR:MODE STEP,(@1)
RES:MODE STEP,(@1)
POW:MODE STEP,(@1)
. The parameters apply to the
.
Keysight N6700C Series User's Guide