Keysight Technologies N6700C Serie Guide D'utilisation page 115

4 Operating the Power System
Ext Selects all digital port pins that have been configured as trigger inputs.
l
Pin<n>Selects a specific pin that is configured as a Trigger Input on the digital port.<n> specifies
l
the pin number. The selected pin must be configured as a Trigger Input in order to be used as a trig-
ger source (refer to Trigger
Transient<n> Selects the output channel's transient system as the trigger source. <n> specifies
l
the channel. When you select a channel, you must also set up that channel's transient system to
generate a trigger out signal. Refer to
For example, to select Bus triggers as the trigger source, use:
Front Panel Menu Reference
Select Transient\TrigSource.
Under Transient trigger source, select Bus. Then press
Select.
Step 9. Initiate the transient trigger system. To enable the trigger system for one transient event or
trigger use:
Front Panel Menu Reference
Select Transient\Control.
Navigate to Initiate. Then press Select.
Step 10. Trigger the output pulse or pulse train.
Front Panel Menu Reference
Select Transient\Control.
Navigate to Trigger. Then press Select.
Program an Arbitrary List
The following procedure shows how to generate the list of voltage changes as illustrated in the
following figure.
Step 1. Set the voltage, current, power, or resistance function for which you want to generate a list to
List mode. This example programs a voltage list. Resistance and Power modes apply to
114
Input).
Generate Trigger Out
To program output 1, use:
TRIG:TRAN:SOUR BUS,(@1)
To program output 1, use:
INIT:TRAN (@1)
*TRG
Signals.
SCPI Command
SCPI Command
SCPI Command
Keysight N6700C Series User's Guide