Publicité
Les langues disponibles
Les langues disponibles
Interface Connections
GPIB Connections
USB Connections
LAN Connections - site and private
Digital Port Connections
This section describes how to connect to the various communication interfaces on your power system.
For further information about configuring the remote interfaces, refer to
Configuration.
If you have not already done so, install the Keysight IO Libraries Suite, which can be
found at www.keysight.com/find/iolib. For detailed information about interface
connections, refer to the Keysight Technologies USB/LAN/GPIB Interfaces Connectivity
Guide included with the Keysight IO Libraries Suite.
GPIB Connections
The following figure illustrates a typical GPIB interface system.
1. If you do not have a GPIB interface card installed on your computer, turn off your computer and
install the GPIB card
2. Connect your instrument to the GPIB interface card using a GPIB interface cable.
3. Use the Connection Expert utility of the Keysight IO Libraries Suite to configure the GPIB card's
parameters.
4. The power system is shipped with its GPIB address set to 5. Use the front panel menu if you need to
change the GPIB address.
5. You can now use Interactive IO within the Connection Expert to communicate with your instrument,
or you can program your instrument using the various programming environments.
Keysight N6700C Series User's Guide
2 Installation
Remote Interface
71
Publicité
