Keysight Technologies N6700C Serie Guide D'utilisation page 67

2 Installation
The following figure shows the paralleled connections for N678xA SMU power modules. Note that
remote sensing is not normally used in Current Priority mode.
Grouping the Outputs
The output grouping function is not available for N678xA SMU power modules.
Once outputs have been connected in parallel, they can be configured or "grouped" to act as a single,
higher-power channel. This applies when programming via the front panel or using SCPI commands.
How to group output channels that have been connected in parallel is discussed under Output
Groups.
If you are not grouping output channels, first program both outputs to the desired output voltage.
Then program the current limit of each output. In Current Priority mode, program the output current of
66 Keysight N6700C Series User's Guide