Keysight Technologies N6700C Serie Guide D'utilisation page 50

DC Power Module Items
Large Sense Jumpers
Sense Connector
Calibration Certificate
Inspect the Unit
When you receive your power system, inspect it for any obvious damage that may have occurred
during shipment. If there is damage, notify the shipping carrier and nearest Keysight Sales and
Support Office immediately. Refer to www.keysight.com/find/assist.
Until you have turned on and checked out the power system, save the shipping carton and packing
materials in case the unit has to be returned.
Review Safety Information
This power system is a Safety Class 1 instrument, which means it has a protective earth terminal. That
terminal must be connected to earth ground through a power source equipped with a ground
receptacle.
Refer to the Safety Summary
installation or operation, check the power system and review this guide for safety warnings and
instructions. Safety warnings for specific procedures are located at appropriate places throughout this
Guide.
Some power modules generate voltages exceeding 60 VDC
Ensure that instrument connections, load wiring, and load connections are either
insulated or covered so that no accidental contact with lethal output voltages can
occur.
Observe Environmental Conditions
Do not operate the instrument in the presence of flammable gases or fumes.
The environmental conditions of the power system are documented under
Characteristics. Basically, the unit should only be operated indoors in a controlled environment.
The dimensions of your instrument as well as an outline diagram are also documented under
Specifications. A fan cools the power system by drawing air through the sides and exhausting it out the
side and back. The instrument must be installed in a location that allows sufficient space at the sides
and back of the unit for adequate air circulation.
Keysight N6700C Series User's Guide
Description
Two large jumpers for local sensing at the output connector.
Only used in N6731B, N6741B, N6754A, N6756A, N6764A,
N6766A, N6773A, N6791A.
A 4-pin connector for connecting sense leads. Wires (p/n
5185-8847) are used for local sensing. Only used in N6753A,
N6755A, N6763A, N6765A, N6792A.
A certificate of calibration referenced to the serial number.
page at the beginning of this guide for general safety information. Before
2 Installation
Part Number
Keysight 0360-2935
Phoenix Contact 3118151
Keysight 1253-5830
Phoenix Contact MC 1,5/4-ST-3,5
N/A
Environmental
49