Publicité
Les langues disponibles
Les langues disponibles
2 Installation
Installing the Mainframe
Module Installation
Rack Mounting
Bench Installation
Redundant Ground for 400 Hz Operation
Module Installation
The information in this section applies if you have purchased an N6700 mainframe
without the modules installed, or if you are adding a module to the mainframe.
Equipment Damage Turn the mainframe off and disconnect the power cord before
installing or removing modules. Observe all standard electrostatic discharge
precautions before handling electronic components.
Modules must be installed next to one another, starting with slot 1. Do not leave any
empty slots between modules, otherwise the power system will not operate.
Any remaining unused slots must have a filler module (N6708A) installed to ensure
proper cooling. Do not install filler modules between modules.
Tools required: T10 Torx driver; Small flat-blade screwdriver
Step 1. Remove the blower cover.
Remove the screws from the top and sides of the blower cover. Tilt the cover up and slide it out.
50
Keysight N6700C Series User's Guide
Publicité
