SOLIS GELATERIA PRO Mode D'emploi page 122

• Note: The PRE-COOL function can only be switched on while the machine is in
standby mode, meaning the machine is plugged in and switched on by pressing
the POWER button but the START/PAUSE button has not yet been pressed.
c) To activate the PRE-COOL function press the PRE-COOL button while the machine
is in standby mode. The control light surrounding the button will change from
white to red to indicate that the machine is working in pre-cooling mode and
will lower inside temperature to -10° to -30°C in 5 - 10 minutes.
d) In PRE-COOL mode, the display will state the temperature in the ice cream bowl
chamber, the PRE-COOLING (T) indicator will illuminate and the rectangles in
Cooling bar (Q) will illuminate one after another to indicate that the machine is
in PRE-COOL mode.
e) The display will state READY and PRESS START will flash as soon as optimal tem-
perature is reached. Add the prepared ice cream mixture into the bowl and put
it into the bowl chamber (provided it is not inserted already) and start prepara-
tion with the START/PAUSE button.
• Note: If the START/PAUSE button is not pressed after the READY indicator has
illuminated, the paddle will start turning after 15 minutes. However, this will not
start ice cream preparation. Ice cream preparation only starts after the
START/PAUSE button is pressed.
f) After 20 minutes, the machine will automatically go from PRE-COOL back to
standby mode. The pre-cooling function can be switched off manually, either by
pressing the PRE-COOL button again or by pressing the START/PAUSE button
which stops the pre-cooling function.
•
Remember:
To start ice cream preparation, in any case the START/PAUSE button has
to be pressed after pre-cooling.
The PRE-COOL function can not be activated when the START/PAUSE but-
ton has been pressed earlier.
122