Publicité
Before using for the first time, wash the parts: See 'Care and Cleaning'.
Care and Cleaning
Always switch off and unplug before cleaning.
A little grease may appear at outlet
The metal surfaces of the temperature sensors may show signs of wear during normal use. This does not affect the
performance of the product.
Do not leave the creaming beater fitted to the mixer when not in use.
Appliance, outlet covers
Wipe with a damp cloth, then dry (Including the feet on the underside of the machine).
Never use abrasives or immerse in water.
Creaming beater
Always remove the flexible wiper blade from the tool before cleaning.
Wash the flexible wiper blade and tool in hot soapy water, then dry thoroughly. Alternatively the parts can be washed
in a dishwasher.
Note: Please inspect the condition of the tool body before and after use and also regularly inspect the condition of the
wiper blade and replace it if there are any signs of wear.
Bowl, Tools, Splashguard, Stir Assist Clip
Wash by hand, then dry thoroughly or wash in the dishwasher (refer to chart
Never use a wire brush, steel wool or bleach to clean your stainless steel bowl. Use vinegar or a suitable descaler to
remove limescale.
If food sticks or burns on the inside of the bowl, remove as much as possible using the spatula provided. Fill the bowl
with warm soapy water and allow to soak. Remove any stubborn deposits using a nylon brush.
Any discolouration of the bowl will not affect its performance.
Drain Hole
Ensure this area is free from food. If necessary use a pipe cleaner or cotton bud to clean.
Temperature sensors
Wipe with a damp cloth then dry thoroughly. Never use abrasives or sharp instruments to clean the sensors.
Steamer Attachment
Always switch off and unplug before removing the attachment from the Stand Mixer.
For easier cleaning always wash the parts immediately after use.
All parts can be washed in hot soapy water, then dried thoroughly. Alternatively they can be washed in the
dishwasher.
Ordinary water and food contains salts and acids which can sometimes effect metal surfaces such as the inside of
the mixer bowl. Should this occur clean with a nylon brush, a non abrasive scourer or a proprietary stainless steel
cleaner.
S
(Refer to chart
)
when you first use it. This is normal - just wipe it off.
5
S
).
Publicité
