Publicité
1
Turn the head-lift lever clockwise and raise the mixer head until it locks.
2
Push the heat shield upwards onto the underside of the mixer head until fully located.
If using the Cooking Chef without heat, it is not necessary to fit the heat shield unless using the Splashguard.
3
Fit the bowl to the base. Turn clockwise to lock into place.
4
Place the required tool in the bowl tool socket or stir tool socket if using the stir tool, locating the pin in the groove and then turn to
lock into position.
To remove a tool, reverse step 4 above. (Always use oven gloves to remove tools after cooking).
Stir Tool – when using the stir tool the stir assist clip can also be used to assist the mixing action, see 'To Fit and Remove your Stir
Assist Clip'. The stir tool can also be used with the whisk.
5
To lower the mixer head, raise it slightly, then turn the head lift lever clockwise. Lower into the locked position.
6
Rest the splashguard on the bowl rim and then slide forward until fully located.
During mixing, ingredients can be added directly to the bowl via the feed chute.
7
To remove the splashguard simply slide it away from the appliance.
Note: The splashguard will remain attached to the heat shield when the mixer head is raised unless removed before lifting the mixer
head.
8
To remove the heat shield, raise the mixer head until it locks. Remove the tool, then pull the heat shield downwards from the
underside of the mixer head. Note: Only fit or remove the splashguard when the mixer head is in the locked position.
9
The viewing angle of the display screen can be adjusted. To adjust the angle of the display screen, hold the bottom of the screen and
gently pull or push into position.
To Assemble The Creaming Beater
Usage Diagram and Usage Instructions
G1
Important
The wiper blade is supplied already fitted and should always be removed before cleaning.
1
Carefully fit the flexible wiper blade onto the tool by locating the base of the wiper blade into the slot then fit one side into the
groove before gently hooking the end in place. Repeat with the other side.
G2
B
10
G3
Publicité
