Publicité
Tool Adjustment
Usage Diagrams and Usage Instructions
Q1
Important
Dough Tool - This tool is set at factory and is not adjustable.
Whisk and K-Beater - The whisk and K-Beater should be almost touching the bottom of the bowl. If necessary adjust the height
using the spanner provided.
Stir Tool and Creaming Beater - The Stir Tool and Creaming Beater should just touch the bottom of the bowl.
Whisk, K-Beater, Creaming Beater - Adjustment
1
Unplug the appliance.
2
Raise the mixer head and insert the whisk, K-Beater or creaming beater.
3
Lower the mixer head. If the clearance needs to be adjusted, raise the mixer head and remove the tool.
4
Using the spanner provided loosen the nut sufficiently to allow adjustment of the shaft. To lower the tool closer to the bottom of the
bowl, turn the shaft anti-clockwise. To raise the tool away from the bottom of the bowl turn the shaft clockwise.
5
Re-tighten the nut.
6
Fit the tool to the mixer and lower the mixer head. (Check its position see points above).
7
Repeat the above steps as necessary until the tool is set correctly. Once this is achieved tighten the nut securely.
Stir Tool Adjustment
1
Unplug the appliance.
2
Raise the mixer head and insert the stir tool.
3
Lower the mixer head. If the tool needs adjustment, raise the mixer head and use the spanner to loosen the nut, then lower the mixer
head.
4
To lower the tool closer to the bottom of the bowl, turn the adjustment wheel clockwise. To raise the tool away from the bottom of
the bowl, turn the adjustment wheel anti-clockwise.
5
Re-tighten the nut.
Q2
28
Publicité
