Instalation Preparation; Fuel Requirements And Recommendations; Fuel Consumption; Ng Pipe Sizing - Champion Global Power Equipment 100199 Mode D'emploi

Model 100199
INSTALLATION
Once the HSB has been placed, check to make sure it is level. If
it isn't, make adjustments prior to installation procedures start.
INSTALLATION PREPARATION
!
Improper installation can result in
!
personal injury and damage to the
generator. It may also result in the
warranty being suspended or voided.
All the instructions must be followed
including location clearances and
pipe size.
Once Site Selection, Preparation and Placement has been
completed, you can proceed to Installation Preparation. Without
these in place you may encounter problems moving forward.
There are a number of key items that MUST be addressed prior
to the physical installation of the HSB. The installation of the HSB
must comply strictly with all applicable codes, standards and
regulations (NFPA 37, NFPA 54, NFPA 58, and NFPA 70).
Check and confirm that the HSB on board controls are "ALL" in
the "OFF" position. This includes; Control panel circuit breaker,
exercise control and both LED controllers.
Champion HSB units have been run and tested at the factory
prior to being shipped. They do not require any type of break-in
period.
24
Part No. 101049 Rev. B
WARNING
CAUTION
!
Never operate the HSB with the engine oil level below
the "ADD" mark on the dipstick, doing so could damage
the engine. Check the oil level and add the appropriate
viscosity and amount indicated on the oil dipstick full
line. Oil viscosity 5 w 30 full synthetic. Refer to Owner's
manual.
IN THE THIS SEGMENT, "INSTALLATION PREPARATION, THE
FOLLOWING WILL BE COVERED;
1.

Fuel Requirements and Recommendations

2.

Fuel Consumption

3. NG Pipe Sizing, flexible fuel line
4. LPG Vapor Pipe Sizing, flexible fuel line
5.

Converting to LPG

6. Full Flow Shut Off Valve
7.

Sediment Trap

8.

Checking Pressure with a Manometer

9. Battery Requirements, Installation & Service
1. FUEL REQUIREMENTS AND
RECOMMENDATIONS
The following NG and LPG fuel information is provided to assist
the fuel installer. This information should not be deemed to be
all inclusive or to conflict with local dry fuel codes. Consult your
local fuel supplier or Fire Marshall for guidance on proper local
codes and installations. Local codes will mandate correct routing
of gaseous fuel line piping around gardens, shrubs and other
landscaping to prevent any damage.
Special considerations should be given when installing the
HSB where local conditions include might flooding, tornados,
hurricanes, earthquakes and unstable ground. These are
considerations for the flexibility and strength of piping and their
connections.
NG is lighter than air and will collect in high areas. LPG is heavier
than air and will settle in low areas.